When lathe of numerical control of system of use FANUC 0i, end when to program, workpiece had been installed at 0 o'clock, mechanical Suo Dinghe airborne travel presses, after undertaking graphical imitate, right now, mechanical coordinate and opposite coordinate produce a change, must be the same as reference point before be machined after imitate so, and the machine tool of coder of very to deploying form, be like Shenyang the CAKDi series of one machine, because did not answer reference point option, after can cutting off the power the system can cutting off the power the system only normally, new electrify eliminates an error, no matter which kinds of means can is opposite treatment brings an influence. Means of settlement: Be over when to program and to be over after the knife, before machine tool lock decides imitate, should use MDI to move cutting tool to be worth to the final coordinate in the program, be like: O0001: T0101: G00 X100. 0Z100.
0; M05; M30; Before machine tool lock decides imitate, use MDI mobile cutting tool. Be like: T0101; G00 X100.
0Z100.
0; MDl moves, park cutting tool the position that the cutting tool in park program is in finally, undertake the machine tool locks up calm imitate again right now, can avoid at 0 o'clock deviate. Attention: If have many cutting tool, should move last in the program place uses cutting tool, be like: O0002; T0101; ... T0202; ... T0303; G00 X100.
0Z100.
0; M05; M30; Answer right now MDI runs T0303; G00 X100.
0Z100.
0; CNC Milling
CNC Machining