The pace receives the note when driver into electric machinery

  • Time:
  • Click:241
  • source:DAHLER CNC Machining
Warning: When receiving the condition driver into Ink> electric machinery, affirm power source of electric machinery Ink> already was shut first please. During driver electrify, cannot disconnect electric machinery. Proposal of hill company electric machinery does not receive electric machinery down-lead the ground to go up or on power source. 4 lines electric machinery can use connection of a kind of means only. 6 lines electric machinery can use connection of two kinds of means: Take a percentage of a deal of series connection, center. Below series connection mode, electric machinery has bigger torsion in the movement below low speed, but cannot resemble receiving in central take a percentage of a deal rapid in that way movement. When series connection runs, electric machinery needs with under electric current of means of central take a percentage of a deal 30% move in order to avoid overheat. 8 lines electric machinery can use connection of two kinds of means: Series connection, shunt-wound. Series connection means has bigger torsion when low speed, and when high speed torsion is lesser. When series connection runs, electric machinery needs with shunt-wound means electric current 50% move in order to avoid overheat. General situation can realize open loop control into electric machinery, the pulse amount that carries an input through driver signal input namely and the angle that frequency realizes a pace to enter electric machinery and speed are controlled, need not feedback signal. But the pace does not suit to use into electric machinery in the circumstance that runs for long with direction, easy burned-out product, stone's throw is normally when be being used namely frequent movement relatively beautiful. CNC Milling CNC Machining